User guide

8
Therearetwowaysofcompletingtheinitialnetworkinstallationofthe
DominionSX:
• UsingaserialcablewithaVT100/equivalent,suchasaPCwith
HyperTerminal.
• UsingEthernet(withaninstallationcomputer).

ThissectiondescribesthestepsnecessarytoconfigureDominionSXfor
useonalocalareane
twork(LA
N).Thefollowingtabledescribesthe
factorydefaultnetworksettingsthatcomewiththeDominionSX.After
unitsareconnectedtothenetwork,thesefactorydefaultsettingsallow
youtoconfiguretheDominionSXfornormaluse.
Default Network Settings
InternetAddress(IP) 192.168.0.192
GatewayAddress 192.168.0.192
SubnetMask 255.255.255.0
CSCPortAddress 5000
PortAddressforCC
Discovery
5000
Username admin(all
lowercase)
Password raritan(all
lowercase)
Note:Thesettingslistedinthetableaboveareonlyapplicableifno
DHCPserverisrunningonthenetwork.IfanDHCPserverisrunningon
alocalnetwork,theDominionSXunitisassignedadifferentIPaddress
fromthedefaultonebytheDHCPserver.
In This Chapter
Pre‐Installation ...................................................................................................9
HardwareInst
allation .......................................................................................9
Chapter 3
Installation