User guide

Appendix D: Server Configuration

275

Configure the Dominion SX to Use an IAS RADIUS Server

ThetaskstosetuptheDominionSXunittouseanIASRADIUISserver

are:

• ConfigureaPrimaryRadiusServer(andoptionalsecondaryRadius

server)

• ConfigureaRadiusport

• Configureasecret(sharedsecret)thatwillbematchedintheIAS

clientconfigurationwithinIAS.

Thefollowingex

amplesh

owsasimplesetupbasedona newIAS

installation.

Note:IftheIASsetupalreadyexists,theseinstructionsmaynotapply

exactlyasshown.

Enable IAS on the Server

1. OntheIASserver,gototheControlPanelandlaunchAddor

RemovePrograms.

2. ClicktheAdd/RemoveWindowsComponentsbutton.

3. HighlightNetworkingServicesthenclicktheDetails...button.

4. PlaceacheckmarknexttotheInternetAuthenticationServicethen

clickOK.

5. ClicktheNext>buttonandcontinuetoco

mpl

etethewizardsteps.

IAS Active Directory Access

IfusingaDomainController,setIAStoaccesstheActiveDirectoryusing

thefollowingsteps:

1. LaunchIAS(Start‐>AllPrograms‐>AdministrativeTools‐>

InternetAuthenticationService).

2. RightclickonInternetAuthenticationService(Local)andselect

Note:RefertothefollowingMicrosoftURLforin

formationab

out

ActiveDirectory:

http://support.microsoft.com/default.aspx?scid=kb;en‐us;321051