User guide

Chapter 15: Power Control
233
Scenario
#1
Configure a DSX port to contain a power
strip device (the port is previously
connected to a power strip)
Pre‐condition AdministratoruserisloggedinviaCLI.
PowerStripdevice(DPX)isphysicallyconnectedto
Port1ofDSX.Administratorisinpowermenu.
Action Entercommand.
PressEnter.
CLIInput setpowerportnamePowerStr1typeDPCS12port1
Scenario
#2
Power strip configuration after factory
reset
Pre‐condition Powerstripdevice(DPX)namedPowerStr1is
physicallyconnectedtoPort1ofDSX.
DSXuserhasalreadyconfiguredtheportasaPower
Strip.
Action LogintoDSXunitwithadministratorprivilegesvia
CLI.
GotoMaintenancemenu
PerformFactoryReset
CLIInput Command:factoryreset

CLIPowerAssociationGroup
Description:Power>PowerGroupsmenu
Scenario
#1
Create new power group
Pre‐condition AdministratoruserisloggedinviaCLI.
Powerstripdevice(DPX)namedPowerStr1is
physicallyconnectedtoPort1ofDSX.
AdministratorisinPower>PowerGroupsmenu.
Action EnterCommand.
PressEnter.