User guide

Chapter 13: Command Line Interface
171
Group Settings:
Name: Anonymous
Class: Observer
Ports:
ToconfigureAnonymousgroupsettingsgotoconfig>usermenuand
executethefollowingcommand:
admin > Config > User > editgroup name Anonymous class
op ports 1,2,3,4,5

Editing group...
Group Anonymous: Configuration Saved

The 'Anonymous' group is successfully configured.

DPAAnonymousaccess:
TheDPAisalreadyconfigured.(SeetheDPAconfigurationsettings
section.)
DPAModeisIP,IP10.0.13.240isassignedtoport1.
Whenaccessingthese
rialportwithAn
onymousportaccess,theuser
nameshouldbeʺAnonymousʺandemptypassword<blank>asisshown
below(TheAnonymousaccessisgrantedifbothfieldsusernameand
passwordareempty<blank>):
ssh -l Anonymous 10.0.13.240
Password:
Authentication successful.
Starting DPA for port 1
Authentication successful.
Escape Sequence is: Control-]
Ifsuppressoptionisʺallʺ,noauthenticationcredentialsareshown.The
userjumpsdirectlytotheta
r
getprompt.
configuration > ports > config port 1 suppress all
ssh -1 Anonymous 10.0.13.240