User guide

Configuring Services
170
dpa Command Example
ThefollowingexamplechoosestheDPAIPmodeIP:
admin > Config > Services > dpa mode IP
Note:WhenanychangesaremadeoverDPAmodeandportsDPA
configuration,theSXdeviceneedstoberebootedtoapplynewsettings.
DPAchangeswillnotbeavailableuntilaftertheDSXisrebooted.
AfterasuccessfulDPAconnection,trythefollowing:
ssh -l sx_user 10.0.13.1
Password:
Authentication successful.
Starting DPA for port 1
Authentication successful.
Escape Sequence is: Control-]
Youcannowgodirectlytoport1usingthenewlyassignedIP.

TodisableDPA(setbydefault,thisoptioncouldbeusedafteryouhave
explicitlyenabledDPAbefore):
admin > Config > Services > dpa mode Normal

Enablingunauthorizedportaccesstoasetofportsas
signedto
ʹAnonymousʹgroup.
UnauthorizedportaccessisonlyavailableforconfiguredDPAmethods.
Usethefollowingcommand:
admin > Security > LoginSettings >
unauthorizedportaccess enable true

Whenunauthorizedportaccessisenabled,itautomaticallyenables
Anonymousgroupandtheuserisabletoconfigureitaccordingtohis
requirement:
admin > Security > LoginSettings >
unauthorizedportaccess
Unauthorized Port Access Settings:
Enable: 1