User guide

Configuring Ports
166
Authentication successful.
Port 1: Configuration Saved.
Afterenteringthepassword,youhavedirectaccesstoport1,using
thenewlyassignedIPspecificallyforport1.
2. ThefollowingexampleconfiguresDPAportsettingsforagroupof
ports(makesureafreerangeofIPsareavailablefordpaIPmode
usage):
admin > Config > Port > config port 1-32 dpaip
10.0.13.200
or
admin > Config > Port > config port * dpaip 10.0.13.200
Inbothcase
s
above,port1willhaveanIPassignedas10.0.13.200,
whileport2willhave10.0.13.201,port310.0.13.203,andetc.

ThefollowingexampleconfiguresDPAportsettingswhenthe
AdministratorchoosesDPAmodeTCPPort.TheAdministratorneedsto
settheSSHorTelnetportvalueassignedfordir
ectportaccess:
1.
admin > Config > Port > config port 1 ssh 7000 telnet
8000
admin > Config > Services > dpa mode TCPPort
Afterthisoptionisenabled,theDSXunitisrestarted.DPAchanges
willnotbeavailableuntilaftertheSXisrebooted.
try ssh -l sx_user -p 7000 10.0.13.13 or telnet -l
sx_user 10.0.13.13 8000
Password:
Authentication successful.
Port 1: Configuration Saved.
Afterenteringthepassword,youhavedirectaccesstoport1,using
thenewlyassignedTCPPorts(eithersshortelnet),spe
cificallyforport
1.
2. Thefol
lowingexampleconfiguresDPAportsettingsforagroupof
ports(makesurenoTCPPortshavebeenassigned,andafreerangeof
TCPPortsareavailablefordpaTCPPortmodeusage):
admin > Config > Port > config port 1-32 ssh 7000 telnet
8000
or
admin > Config > Port > config port * ssh 7000 telnet
8000