User guide

Chapter 13: Command Line Interface
165
Command Example
admin > ports >config port 1 name ld1 bps 115200 parity
odd flowcontrol hw detect true escapemode none emulation
VT100

Thefollowingcommanddisplaysthecurrentsettingsforport1:
admin > Config > Port > config port 1
Port number 1:
Name: Port1
BPS: 9600
Parity: 0
Flow control: 0
RSC Terminal Emulation: VT100
Disconnect: Disabled
Application: RaritanConsole
Exit String: 
Escape: Control-]
DPA:
IP: 0.0.0.0
Telnet Port: 0
SSH Port: 0
Always Active: False
Messages suppressed: none

ThefollowingexampleconfiguresDPAportsettingswhenthe
AdministratorchoosesDPAmodeIP.TheIPAddressisassignedfor
directportaccess
usingthefoll
owingcommand:
1. admin > Config > Port > config port 1 dpaip 10.0.13.1
admin > Config > Services > dpa mode IP (uppercaseforIP!)
Afterthisoptionisenabled,theDSXunitisrestarted.DPAchanges
willnotbeavailableuntilaftertheSXisrebooted.
ssh -l sx_user 10.0.13.1
Password: