User guide

Configuring Network
158
gwipaddress GatewayIPAddressobtainedfromtheIP
administrator.
mode<auto|100fdx> SetEthernetModetoautodetectorforce
100Mbpsfullduplex(100fdx)
Interface Command Example
Thefollowingcommandenablestheinterfacenumber1,setstheIP
address,mask,andgatewayaddresses,andsetsthemodetoautodetect.
Admin Port > Config > Network > interface enable true if
lan1 ip 192.16.151.12 mask 255.255.255 gw 192.168.51.12
mode auto
IPForwarding Command
Theipforwardingcommandisusedtoconfiguretheabilitytoforward
betweentwonetworks.
Thesyntaxoftheipfowardingis:
ipforwarding [enable <true|false>]
Ipforwarding Command Example
ThefollowingcommandenablestheIPForwarding:
admin > Config > Network > ipforwarding enable true

Name Command
Thenamecommandisusedtoconfigurethedeviceandhostname.
Thesyntaxforthedevicenameandhostnameis:
name [unitname name] [domain name] [force <true|false>]
name Command Example
Thefollowingcommandsetsthedevicename:
Admin Port > Config > Network > name unitname <device
name> domain <host name> force trues