User guide

Chapter 13: Command Line Interface
157
Note:Alloperationsthatnormallytriggerarebootorprompttheuserfor
feedbacksarenowaddedanewparameternamedforce.Thisforce
parameterpreventsreboot,promptingorbothfromtakingplaceuntilall
configurationsarecompleted.Thecommandsthatnowhaveaforce
parameterare:ethernetfilover(seeʺEthernetfailoverCommandʺon
pa
ge15
7),interface(se
eʺInterfaceCommandʺonpage157),name(see
ʺNameComm
andʺonpage158),ports(seeʺPortsCommandʺonpage
159),factoryreset(se
eʺFactoryresetCommandʺonpage194)and
reboot(seeʺRebootComm
andʺonpage196).
Ethernetfailover Command
Theethernetfailovercommandisusedtoenableanddisabletheabilityto
failoverfromoneLANtoanother.
Thesyntaxoftheethernetfailovercommandis:
ethernetfailover [enable <true|false>] [interval value]
[force <true|false>]
Interface Command
TheinterfacecommandisusedtoconfiguretheDominionSXnetwork
interface.Whenthecommandisaccepted,theunitwillautomatically
rebootanddroptheconnection.Youmustthenreconnectusingthenew
IPaddressandtheusernameadminandpasswordnewp/wenteredin
theresettingfactorydefaultpasswordsection.
Thesyntaxoftheint
e
rfacecommandis:
interface [enable <true|false>] [if <lan1 | lan2>] [dhcp
<true|false>] [ip ipaddress] [mask subnetmask] [gw
ipaddress] [mode <auto | 100fdx>] [force <true|false>]
Thenetworkcommandoptionsaredescribedinthefollowingtable.
Command Description
enable<true|false> Enable/DisableInterface
dhcp EnableDHCPasipconfiguration
if<lan1|lan2> SelectLANinterfaceyouareconfiguring
ipipaddress IPAddressoftheDominionSXassignedfor
accessfromtheIPnetwork
masksubnetmask SubnetMaskobtainedfromtheIP
administrator