User guide

Chapter 13: Command Line Interface
137
Date and Time Configuration
Note:Itisimportanttosetthedateandtimecorrectlytoensurethatlog
entriesandeventscontainthecorrecttimestamp.
Returntothetopmenulevelbyenteringthetopcommand.Usethe
followingcommandtoviewthecurrentdateandtimesettings:
Admin Port > Config > Time > clock

Thesystemdisplaysthecurrentsettings.Forexample:
Date /Time Settings:
Date : 2006-09-20 23:20:24
Timezone : 13
Usethefollowingstepstosettheuserdateandtime.
1. Admin Port > Config > Time > timezonelist
2. Admin Port > Config > Time > clock tz 21 datetime
"2006-09-23 13:22:33"
Setting Network Parameters
Networkparametersareconfiguredusingtheinterfacecommand.
Admin Port > Config > Network > dhcp false interface
enable true if lan1 ip 192.16.151.12 mask 255.255.255 gw
192.168.51.12
Whenthecommandisaccepted,theunitautomaticallyrebootsanddrops
theconnection.YoumustreconnecttotheunitusingthenewIPaddress
andtheusernameadminandpasswordnewp/wenteredintheresetting
factorydefaultpasswordsection.
Important:Ifthepasswordisfo
rgotten,theDominionSXwillneedto
beresettothefactorydefaultfromtheresetbuttonontherearpanel
andtheinitialconfigurationtaskswillneedtobeperformedagain.
TheDominionSXnowhasthebasicconfigurationandcanbeaccessed
remotelyviaSSH,GUIorlocallyusingthelocalserialport.Next,the
administratorneedstoconfiguretheusersandgroups,services,security,
andserialportstowhichtheserialtargetsareattachedtotheDominion
SX.