User guide

Chapter 13: Command Line Interface
131
 username
SeetheLogin(onpage131)sectionfo
rlogininformation.
To Change the Local Port Parameters:
Thelocalportisenabledbydefaultandisenabledonbothserialportsfor
unitswithtwolocalportsat9600bps.
¾
To change the local port parameters:
forexample,tochangethebaudratefromthedefault9600bpsto
115200bps,enter:
Admin Port > Config > Services > lpa enable true bps
115200
¾
To disable local port access:
Admin Port > Config > Services > lpa enable false
Login
¾ To log in, enter the user name admin as shown:
Login: admin
Thepasswordpromptappears.Enterthedefaultpassword:raritan
Password: