User guide

Local Port Connection to the Dominion SX
130
Accessing Telnet from a Windows PC
¾ To open a Telnet session from a Windows PC:
1. ChooseStartup>Run.
2. TypeTelnetintheOpentextbox.
3. ClickOK.TheTelnetwindowopens.
4. Atthepromptenterthefollowingcommand:Microsoft Telnet>
open <IP address>
where<IPaddress>istheDominionSXIPaddress.
5. PressEnter.Thefollowingmessageappears:Connecting To <IP
address>... The login aspromptthenappears.
SeetheLo
gin(onpa
ge131)sectionforlogininformation.
Local Port Connection to the Dominion SX
IfyourDominionSXʹsterminalportusesanRJ45jack,aspecialcable
(CRLVR)isusedwithanASCSDB9Fconnectorontheclientmachine.The
CRLVRmayalsobeusedifRJ45‐RJ45connectiontolocalportis
established‐thatis,ifyouconnectthelocalportofaDominionSXde
vice
asaser
ialtargettoanotherDominionSX.
Port Settings
Ensurethattheportsettings(serialcommunicationparameters)are
configuredasfollows:
• Databits=8
• Parity=None
• Stopbits=1
• FlowControl=None
Connection
¾ To make a local port connection:
1. OpenaHyperTerminalapplicationorequivalent.
2. EnsuretheHyperTerminalisconfiguredtocommunicatewiththe
portthatisconnectedtotheDominionSXunit.
3. DisableFlowcontrol.
4. PressEnterandthefollowingpromptappears: