User guide

Chapter 2: Installation and Configuration
33
10. To configure new network settings, at the Network prompt, type
interface followed by one of the following commands and its
appropriate argument (option), then press Enter.
Command
Argument
Options
ipauto
none|dhcp
none - Enables you to
manually specify an IP
address for the device.
You must follow this option
with the ip command and
the IP address, as shown
in the following example:
interface ipauto
none ip
192.168.50.12
dhcp - Automatically
assign an IP address to
the device on startup.
interface ipauto
dhcp
ip
IP address
The IP address to assign
to the device. To manually
set an IP address for the
first time, this command
must be used with the
ipauto command and the
none option. See ipauto
for information. After you
have manually assigned
an IP address once, you
can use the ip command
alone to change the IP
address.
mask
subnet mask
Command column should
be "interface"
interface | ip | ...
interface | mask | The
subnet mask IP address
interface | gw | The
gateway IP address
interface | mode |
....
gw
IP address
The gateway IP address
mode
mode
The Ethernet mode. You
have the following choices: