User guide

Chapter 2: Installation and Configuration

b. Using a text editor, disable all non-KX II-101-V2 supported

resolutions.

c. Disable the virtual desktop feature (not supported by the KX II-

101-V2).

d. Check blanking times (+/- 40% of VESA standard).

e. Restart computer.

Note: If you change the video resolution, you must log off of the target

server and log back in for the video settings to take effect.

Note for Red Hat and Fedora KVM Target Servers

If you are running Red Hat

on the target server using a USB CIM, and

are experiencing problems with the keyboard and/or mouse, there is an

additional configuration setting you can try.

Tip: You might have to perform these steps even after a fresh OS

installation.

To configure Red Hat servers using USB CIMs:

1. Locate the configuration file (usually /etc/modules.conf) in your

system.

2. Using the editor of your choice, make sure that the alias usb-

controller line in the modules.conf file is as follows:

alias usb-controller usb-uhci

Note: If there is another line using usb-uhci in the /etc/modules.conf

file, it needs to be removed or commented out.

3. Save the file.

4. Reboot the system in order for the changes to take effect.

Linux Settings (for Standard Mouse Mode)

Note: The following settings are optimized for Standard Mouse mode

only.

To configure KVM target servers running Linux

(graphical user

interface):

1. Configure the mouse settings:

a. Red Hat 5 users, choose Main Menu > Preferences > Mouse.

Red Hat 4 users, choose System > Preferences > Mouse. The

Mouse Preferences dialog appears.

b. Click on the Motion tab.