User guide

Appendix D: Informational Notes
206
HP UX RX 1600 Keyboard and Mouse Configuration
If you are using an HP
®
UX RX 1600 running UNIX
®
, do the following to
connect the device to the target:
 Verify you are using KX II-101-V2 firmware 2.0.20.5.6964 or higher.
 Use the USB cable that is supplied with the KX II-101-V2 .
 Set the Host Interface field on the Keyboard/Mouse Setup page to
USB. See Keyboard/Mouse Setup (on page 115).
 Verify that the Enable Absolute Mouse and Use Full Speed
checkboxes on the Port page are not selected.
 Use either Intelligent or Standard Mouse mode. Do not use Absolute
Mouse mode.
Compaq Alpha and IBM P Server Mouse Mode Limitation
When connecting to either Compaq
®
Alpha servers or IBM
®
P servers
through the KX II-101-V2, you must use Single Mouse mode. See
Working with Target Servers (on page 35).
Windows 2000 and Windows 2003 Server Keyboard Limitations
Due to an operating system limitation, the following keyboard
combinations do not work with a US-International keyboard layout when
using the Windows 2000
®
operating system and Windows 2003
®
servers.
 Right Alt+D
 Right Alt+I
 Right Alt+L
Note: Right Alt may be labeled as AltGr on keyboards that specifically
have US/International markings on the keys.
CC-SG
Proxy Mode and MPC
If you are using KX II in a CC-SG configuration, do not use the CC-SG
proxy mode if you are planning to use the Multi-Platform Client (MPC).