User guide

Configuring the KX II-101

Thecurrentinterfacesettingsappear:



10. Toconfigurenewnetworksettings,attheNetworkprompt,type

interface followedbyoneofthefollowingcommandsandits

appropriateargument(option),thenpressEnter.

Command Argument Options

ipauto none|dhcp none‐EnablesyoutomanuallyspecifyanIPaddressforthedevice.Youmust

followthisoptionwiththeipcommandandtheIPaddress,asshowninthe

followingexample:

interface ipauto none ip 192.168.50.12

dhcp‐AutomaticallyassignanIPaddresstothedeviceonstartup.

ip IPaddress TheIPaddresstoassigntothedevice.TomanuallysetanIPaddressforthe

firsttime,thiscommandmustbeusedwiththeipautocommandandthenone

option.Seeipautoforinformation.AfteryouhavemanuallyassignedanIP

addressonce,youcanusetheipcomm

andalonetochangetheIPaddress.

mask subnetmask ThesubnetmaskIPaddress.

gw IPaddress ThegatewayIPaddress

mode mode TheEthernetmode.Youhavethefollowingchoices:

auto‐Automaticallysetsspeedandinterfacemodebasedonthenetwork.

10hdx‐10Mbs,halfduplex.

10fdx‐10Mbs,fullduplex

100hdx‐100Mbs,halfduplex

100fdx‐100Mbs,fullduplex