User guide

Chapter 3: Installation and Configuration
27
Using a Terminal Emulation Program
YoucanusetheAdminserialconsolewithaterminalemulation
programlikeHyperTerminaltosetthefollowingconfiguration
parametersfortheKXII‐101:
• IPaddress
• Subnetmaskaddress
• Gatewayaddress
• IPaccesscontrol
• LANspeed
• LANinterfacemode
Touseaterminalemulationprogra
mwiththeKXII‐101,youmustfirst
connecttheincludedRS‐232serialcablefromtheAdminportontheKX
II‐101totheCOM1portonyourPC.SeeusingtheUsingtheAdminPort
(onpage20)forin
formation.
Fordemonstrationpurposes,theterminalemulationprogramdescribed
inthissectionisHyperTerminal.Youcanuseanyterminalemulation
program.
¾ To use a terminal emulation program to configure the
KX II-101:
1. ConnecttheKXII‐101toalocalPCusingtheincludedRS‐232serial
cable.
ConnecttotheAdminportontheKXII‐10
1andtheCOM1porton
thePC.
2. Launchtheterminalemulationprogramyouwanttouseto
configuretheKXII‐101.
3. Setthefollowingportsettingsintheterminalemulationprogram:
 Bitspersecond:115200
 Databits:8
 Parity:None
 Stopbits:1