User guide

Connecting the KX II-101
20
Connecting to the Network
ConnectastandardEthernetcablefromthenetworkportlabeledLANto
anEthernetswitch,hub,orrouter.TheLANLEDsthatappearabovethe
EthernetconnectionindicateEthernetactivity.Theyellowoneblinks
whiletheKXII‐101isinuse,indicatingIPtrafficat10Mbps.Thegreen
lightindicatesa100
Mbpsconnectionspeed.
Powering the KX II-101
TheKXII‐101canbepoweredwitheithertheincludedstandardAC
powerpackorbyPoE(PoweroverEthernet).
• ForstandardACpower,plugtheincludedACpoweradaptorkit
intothePowerPortandplugtheotherendintoanearbyACpower
outlet.
• ForPoE,a
ttacha10/100MbpscabletotheLANport,andplugthe
otherendintoaPoE‐provisionedLAN.
AfterKXII‐101ispoweredON,itgoesthroughaboot‐upsequence,
duringwhichtheblueRaritan‐logoLEDwillblinkforabout45
seconds.Uponsuccessfulboot‐up,theback‐li
tLEDremainslit.
Using the Admin Port
TheAdminportenablesyoutoperformconfigurationandsetupforthe
KXII‐101usingaterminalemulationprogramlikeHyperTerminal.Plug
themin‐DINendoftheincludedserialcableintotheAdminportofthe
KXII‐101andplugtheDB9endintoaserialportonyou
rPCorlaptop.
Theserialportcommunicationsettingsshouldbeconfiguredto:to
115,200Baud,8databits,1stopbit,noparity,andnoflowcontrol.
ForinformationaboutconfiguringtheKXII‐101usingtheADMINport,
seeUsingaTerminalEmulationProgram.