User guide

Configuring the Target Server
10
¾ To change the command line resolution:
1. Runthefollowingcommand:
# eeprom output-device=screen:r1024x768x75
where1024x768x75isanyresolutionthattheKXII‐101supports.
2. Restartcomputer.
GUI Resolution/32 Bit
¾ To check the GUI resolution on 32 bit cards:
1. Runthefollowingcommand:
# /usr/sbin/pgxconfig –prconf
¾ To change the GUI resolution on 32 bit cards:
1. Runthefollowingcommand:
# /usr/sbin/pgxconfig –res1024x768x75
where1024x768x75isanyresolutionthattheKXII‐101supports.
2. Restartcomputer.
GUI Resolution/64 Bit
¾ To check the GUI resolution on 64 bit cards:
1. Runthefollowingcommand:
# /usr/sbin/m64config –prconf
¾ To change the resolution on 64 bit cards:
1. Runthefollowingcommand:
# /usr/sbin/m64config –res1024x768x75
where1024x768x75isanyresolutionthattheKXII‐101supports.
2. Restartcomputer.
GUI Resolution/Solaris 8
¾ To check the resolution on Solaris 8 for 32 bit and 64
bit cards:
1. Runthefollowingcommand:
# /usr/sbin/fbconfig –prconf