User guide

Chapter 12: Command Line Interface (CLI)
171
Name Command
Thenamecommandisusedtoconfigurethedeviceandhostname.
Thesyntaxforthedevicenameis:
name devicename <>
Thesyntaxforthehostnameis:
name hostname <>
name Command Example
Thefollowingcommandsetsthedevicename:
Admin Port > Config > Network > name devicename <device
name>
Thefollowingcommandsetsthehostname:
Admin Port > Config > Network > name hostname <host name>
Interface Command
TheinterfacecommandisusedtoconfiguretheKXII‐101network
interface.Whenthecommandisaccepted,theunitwilldropthe
HTTP/HTTPSconnectionandinitializeanewnetworkconnection.All
HTTP/HTTPSusersmustreconnecttothedeviceusingthenewIP
addressandthecorrectusernameandpassword.SeeIn
stallationand
Configuration(onpage8)forinform
ation.
Thesyntaxoftheinterfacecommandis:
interface [ipauto <none|dhcp>] [ip <ipaddress>] [mask
<subnetmask>] [gw <ipaddress>] [mode
<auto/10hdx/10fdx/100hdx/100fdx]
Thenetworkcommandoptionsaredescribedinthefollowingtable.
Command Option Description
ipauto StaticordynamicIPaddress.
ipipaddress IPAddressoftheKXII‐101assignedfor
accessfromtheIPnetwork
masksubnetmask SubnetMaskobtainedfromtheIP
administrator
gwipaddress GatewayIPAddressobtainedfromthe
IPadministrator.
mode<auto|100fdx> SetEthernetModetoautodetector
force100Mbpsfullduplex(100fdx)