User guide

Associate KVM Target Servers to Outlets (Port Page)
136
Note:Whenapowerstripisassociatedtoatargetserver(port),the
outletnameisreplacedbythetargetservername(evenifyouassigned
anothernametotheoutlet).
¾ To name the power strip (and outlets):
Note:CommandCenterServiceGatewaydoesnotrecognizepowerstrip
namescontainingspaces.
1. ChangetheNameofthepowerstriptosomethingyouwill
remember.
2. Changethe(Outlet)Nameifdesired.(OutletnamesdefaulttoOutlet
#.)
3. ClickOK.
¾ To cancel without saving changes:
• ClickCancel.
Associate KVM Target Servers to Outlets (Port Page)
ThisPortpageopenswhenyouselectaportfromthePortConfiguration
pagethatisconnectedtoatargetserver.Fromthispage,youcanmakea
powerassociationsandchangethePortNametosomethingmore
descriptive.
Aservercanhaveuptofourpowerplugsyoucanassociatewithth
e
powerstrip.Fromthispage,youcandefinethoseassociationssothat
youcanpoweron,poweroff,andpowercycletheserverfromthePort
Accesspage,asshownbelow.
