User guide

Revision: January 2014 Copyright © 2014 Raritan, Inc Page 6 of 11
Blade
Chassis
DCIM-PS2 DCIM-USBG2 D2CIM-VUSB D2CIM-DVUSB
Dell 1855
Dell1955


(connected to blade)

(connected to blade)

(connected to blade)
Dell
M1000e

HP c3000
HP c7000

(connected to blade)

(connected to blade)

(connected to blade)
Cisco UCS

(connected to blade)

(connected to blade)

(connected to blade)
IBM H
IBM E
 
IBM S
IBM HT

Haven’t tested and
certified these for virtual
media
IBM T

Generic
 
In the above table, if the check () is accompanied by the phrase “(connected to blade)”, then the
CIM is connected to each individual blade server. Otherwise the CIM connects to the blade chassis’
internal KVM switch or the management module.
When connecting to individual Dell 1855/1995 blades, the “USB Front Dongle for Dell PowerEdge
1855/1955” cable is required; manufacturer part number N8138 and Dell part number 310-6484.
When connecting to individual HP c3000 and c7000 blades, the “HP c-Class Blade SUV Cable” is used;
part # is 416003-001. Note: the internal KVM module for the HP c3000 is not supported in this
release.
Virtual media and advanced mouse synchronization is supported on blade servers where a CIM is
connected to each blade server, assuming the operating system on the blade supports these features.
Virtual media is also supported on the IBM Blade Center E and H chassis when using the D2CIM-
DVUSB with the gray USB plug connected to the media tray (front panel) and the black plug to the
management module (back panel). The connection to the Media Tray (front panel) will require the use
of an USB extension cable connected to the gray USB plug on the D2CIM-DVUSB. Auto-discovery
must be enabled on the KX III Port Configuration page for virtual media to work.
See the documentation and release notes for more information on the blade server feature.
 Smart Card and CAC Usage
The Dominion KX III based Smart Card / CAC Solution is available. The D2CIM-DVUSB, D2CIM-
DVUSB-xxx CIMs are required for Smart Card and US Government Common Access Card
(CAC) use. No other CIMs will support a Smart Card connection to a target server.
 Digital Audio over IP
The Dominion KX III based Audio over Virtual Media feature is available. The D2CIM-DVUSB and
D2CIM-DVUSB-xxx digital CIMs support audio.
 Connecting a Dominion KX III to a Paragon II User Station
The DCIM-USBG2 and the DCIM-PS2 should be used to connect the Dominion KX III to a Paragon II
User Station. This configuration is used to provide KVM-over-IP access to the User Station.
 Paragon II Dual CIMS (P2CIM-APS2DUAL & P2CIM-AUSBDUAL)
The Paragon II “Dual CIMs” are supported: