User guide

83
In This Chapter
Overview .................................................................................................. 83
Turning Outlets On/Off and Cycling Power ............................................. 84
Overview
The Dominion KX II allows you to control Raritan PX and RPC series
power strip outlets connected to the Dominion KX II through a
D2CIM-PWR.
Once a PX or RPC series is setup and then attached to the Dominion KX
II, the power strip and its outlets can be controlled from the Powerstrip
page in the Dominion KX II interface. This page is accessed by clicking
on the Power menu at the top of the page.
The Powerstrip page will display power strips attached to the Dominion
KX II for which the user has been granted appropriate port access
permissions. In the case of tiered configurations, the Powerstrip page will
display both power strips attached to the base and tiered Dominion KX
IIs, for which the user has been granted appropriate port access
permissions.
Note: For information on setting up a PX, see the Dominion PX User
Guide.
From the Powerstrip page, you are able to turn the outlets on and off, as
well as cycle their power. You are also able to view the following power
strip and outlet information:
 Powerstrip Device Information:
 Name
 Model
 Temperature
 Current Amps
 Maximum Amps
 Voltage
 Power in Watts
 Power in Volts Ampere
 Outlet Display Information:
 Name - Named assigned to the outlet when it was configured.
Chapter 4
Power Strip (Rack PDU) Outlet
Control