User guide

Chapter 2: Installation and Configuration

a. Choose Main Menu > Preferences > Mouse. The Mouse

Preferences dialog appears.

b. Open the Motion tab.

c. Within the Speed group, set the Acceleration slider to the exact

center.

d. Within the Speed group, set the Sensitivity towards low.

e. Within the Drag & Drop group, set the Threshold towards small.

f. Close the Mouse Preferences dialog.

Note: If these steps do not work, issue the xset mouse 1 1 command

as described in the Linux command line instructions.

2. Configure the screen resolution:

a. Choose Main Menu > System Settings > Display. The Display

Settings dialog appears.

b. On the Settings tab, select a Resolution supported by the

Dominion KX II.

c. Click OK.

Note: Once connected to the target server, in many Linux graphical

environments, the <Ctrl> <Alt> <+> command will change the video

resolution, scrolling through all available resolutions that remain enabled

in the XF86Config or /etc/X11/xorg.conf, depending on your X server

distribution

Note: If you change the video resolution, you must log out of the target

server and log back in for the video settings to take effect.

SUSE Linux 10.1 Settings

Note: Do not attempt to synchronize the mouse at the SUSE Linux

prompt. You must be connected to the target server to synchronize the

mouse cursors.

To configure the mouse settings:

1. Choose Desktop > Control Center. The Desktop Preferences dialog

appears.

2. Click Mouse. The Mouse Preferences dialog appears.

3. Open the Motion tab.

4. Within the Speed group, set the Acceleration slider to the exact

center position.

5. Within the Speed group, set the Sensitivity slider to low.

6. Within the Drag & Drop group, set the Threshold slider to small.