User guide

230
In This Chapter
Overview ................................................................................................ 230
Accessing the Dominion KX II Using CLI .............................................. 231
SSH Connection to the Dominion KX II ................................................. 231
Telnet Connection to the Dominion KX II .............................................. 232
Logging In .............................................................................................. 233
Navigation of the CLI ............................................................................. 234
Initial Configuration Using CLI ............................................................... 235
CLI Prompts ........................................................................................... 236
CLI Commands ...................................................................................... 236
Administering the Dominion KX II Console Server Configuration
Commands ............................................................................................ 237
Configuring Network .............................................................................. 238
Overview
The Command Line Interface(CLI) can be used to configure the
Dominion KX II network interface and perform diagnostic functions
provided you have the appropriate permissions to do so.
The following figures describe an overview of the CLI commands. See
CLI Commands (on page 236) for a list of all the commands, which
include definitions and links to the sections in this chapter that give
examples of these commands.
The following common commands can be used from all levels of the CLI
to the preceding figure: top, history, log off, quit, show, and help.
Note: Both IPv4 and IPv6 addresses are supported.
Chapter 12
Command Line Interface (CLI)