User guide

Chapter 8: Device Management
163
Associating Outlets with Target Servers on KX II
The Port page opens when you click on a port on the Port Configuration
page. From this page, you can make power associations, change the
port name to something more descriptive, and update target server
settings if you are using the D2CIM-VUSB CIM. The (CIM) Type and the
(Port) Name fields are prepopulated; note that the CIM type cannot be
changed.
A server can have up to four power plugs and you can associate a
different power strip with each. From this page, you can define those
associations so that you can power on, power off, and power cycle the
server from the Port Access page.
To use this feature, you will need:
 Raritan remote power strip(s)
 Power CIMs (D2CIM-PWR)
To make power associations (associate power strip outlets to
KVM target servers):
Note: When a power strip is associated to a target server (port), the
outlet name is replaced by the target server name (even if you assigned
another name to the outlet).
1. Choose the power strip from the Power Strip Name drop-down list.
2. For that power strip, choose the outlet from the Outlet Name
drop-down list.
3. Repeat steps 1 and 2 for all desired power associations.
4. Click OK. A confirmation message is displayed.
To change the port name:
1. Type something descriptive in the Name field. For example, the
name of the target server would be a likely candidate. The name can
be up to 32 alphanumeric characters and can include special
characters.
2. Click OK.