User guide

Chapter 3: Working with Target Servers
62
Auto-Sense Video Settings
The Auto-sense Video Settings command forces a re-sensing of the
video settings (resolution, refresh rate) and redraws the video screen.
To automatically detect the video settings, do one of the
following:
• Choose Video > Auto-sense Video Settings or click the Auto-Sense
Video Settings button
from toolbar. A message opens stating
that the auto adjustment is in progress.
Calibrate Color
Use the Calibrate Color command to optimize the color levels (hue,
brightness, saturation) of the transmitted video images. The Dominion
KX II color settings are on a target server-basis.
Note: The Calibrate Color command applies to the current connection
only.
To calibrate the color, do one of the following:
• Choose Video > Calibrate Color or click the Calibrate Color button
. The target device screen updates its color calibration.
Video Settings
Use the Video Settings command to manually adjust the video settings.
To change the video settings:
1. Choose Video > Video Settings or click the Video Settings button
in the toolbar to open the Video Settings dialog.
2. Adjust the following settings as required. As you adjust the settings
the effects are immediately visible:
a. Noise Filter
The Dominion KX II can filter out the electrical interference of
video output from graphics cards. This feature optimizes picture
quality and reduces bandwidth. Higher settings transmit variant
pixels only if a large color variation exists in comparison to the
neighboring pixels. However, setting the threshold too high can
result in the unintentional filtering of desired screen changes.
Lower settings transmit most pixel changes. Setting this
threshold too low can result in higher bandwidth use.