User guide

Chapter 2: Installation and Configuration
30
3. Select the "Prompt on log off" checkbox and click OK. This option
prompts you to save your current session when you log off.
4. Upon logging out, select the "Save current setup" option from the
dialog.
5. Click OK.
Tip: If you do not want to be prompted upon log off, follow these
procedures instead.
To make your settings permanent in Linux (no prompt):
1. Choose Desktop > Control Center > System > Sessions.
2. Click the Session Options tab.
3. Deselect the "Prompt on the log off" checkbox.
4. Select the "Automatically save changes to the session" checkbox
and click OK. This option automatically saves your current session
when you log off.
Sun Solaris Settings
To configure KVM target servers running Sun Solaris:
1. Set the mouse acceleration value to exactly 1 and the threshold to
exactly 1. This can be performed from:
 The graphical user interface:
 The command line: xset mouse a t (where “a” is the
acceleration and “t” is the threshold.)
2. All KVM target servers must be configured to one of the display
resolutions supported by the Dominion KX II. The most popular
supported resolutions for Sun machines are:
Display resolution Vertical refresh rate Aspect ratio
1600 x 1200 75 Hz 4:3
1280 x 1024 60,75,85 Hz 5:4