User guide

Chapter 2: Installation and Configuration

 Fade or slide menus into view

 Fade or slide ToolTips into view

 Fade out menu items after clicking

3. Click OK.

4. Close the Control Panel.

SUSE Linux 10.1 Settings

Note: Do not attempt to synchronize the mouse at the SUSE login

prompt. You must be connected to the target server to synchronize the

mouse cursors.

To configure the mouse settings:

1. Choose Desktop > Control Center. The Desktop Preferences dialog

appears.

2. Click Mouse. The Mouse Preferences dialog appears.

3. Open the Motion tab.

4. Within the Speed group, set the Acceleration slider to the exact

center position.

5. Within the Speed group, set the Sensitivity slider to low.

6. Within the Drag & Drop group, set the Threshold slider to small.

7. Click Close.

To configure the video:

1. Choose Desktop Preferences > Graphics Card and Monitor. The

Card and Monitor Properties dialog appears.

2. Verify that a Resolution and Refresh Rate is in use that is supported

by the Dominion KX II. See Supported Video Resolutions (on page

254) for more information.

Note: If you chang

e the vid

eo resolution, you must log off of the

target server and log back in for the video settings to take effect.

Make Linux Settings Permanent

Note: These steps may vary slightly depending on the specific version of

Linux in use.

To make your settings permanent in Linux (prompt):

1. Choose System Menu > Preferences > Personal > Sessions.

2. Click the Session Options tab.