User guide

Chapter 12: Dominion KX II Local Console
253
Resetting the Dominion KX II Using the Reset Button
At the back of the Dominion KX II, there is a Reset button. It is recessed
to prevent accidental presses (you will need a pointed object to use this
button).
The actions that are performed when the Reset button is pressed are
defined in the graphical user interface. See Encryption & Share (on
page 207) for more information.
Note: It is recom
m
ended that you save the audit log prior to performing a
factory reset. The audit log is deleted when a factory reset is performed
and the reset event is not logged on the audit log. For more information
about saving the audit log, see Audit Log (on page 213).
To reset the device:
1. Power off the Dominion KX II device.
2. Use a pointed object to press and hold the Reset button.
3. While continuing to hold the Reset button, power the Dominion KX II
device back on.
4. Continue holding the Reset button for 5-10 seconds. Once the
device has been reset, two short beeps signal its completion.