User guide

Chapter 11: Command Line Interface (CLI)
241
Configuring Network
The network menu commands are used to configure the Dominion KX II
network adapter.
Commands Description
interface Configure the Dominion KX II device network
interface.
name Network name configuration
ipv6 Set/get IPv6 network parameters.
Interface Command
The Interface command is used to configure the Dominion KX II network
interface. The syntax of the interface command is:
interface [ipauto <none|dhcp>] [ip <ipaddress>]
[mask <subnetmask>] [gw <ipaddress>] [mode <mode>]
Set/Get ethernet parameters
ipauto <none|dhcp> IP auto configuration (none/dhcp)
ip <ipaddress> IP Address
mask <subnetmask> Subnet Mask
gw <ipaddress> Gateway IP Address
mode <mode> Set Ehternet Mode
(auto/10hdx/10fdx/100hdx/100fdx/1000fdx)
Interface Command Example
The following command enables the interface number 1, sets the IP
address, mask, and gateway addresses, and sets the mode to auto
detect.
Admin > Config > Network > interface ipauto none ip
192.16.151.12 mask 255.255.255.0 gw 192.168.51.12
mode auto
Note: Both IPv4 and IPv6 addresses are supported.