User guide

Chapter 2: Installation and Configuration
15
Changing the Default Password
The Dominion KX II ships with a default password. The first time you
start the Dominion KX II you are required to change that password.
To change the default password:
1. Power on the Dominion KX II using the power switch(es) at the back
of the unit. Wait for the Dominion KX II unit to boot. (A beep signals
that the boot is complete.)
2. Once the unit has booted, the Dominion KX II Local Console is
visible on the monitor attached to the Dominion KX II local port. Type
the default username (admin) and password (raritan) and click Login.
The Change Password screen is displayed.
3. Type your old password (raritan) in the Old Password field.
4. Type a new password in the New Password field and retype the new
password in the Confirm New Password field. Passwords can be up
to 64 characters in length and can consist of English alphanumeric
characters and the special characters.
5. Click Apply.
You will receive confirmation that the password was successfully
changed. Click OK. The Port Access page is displayed.
Note: The default password can also be changed from the Raritan Multi-
Platform Client (MPC).
Assigning an IP Address
These procedures describe how to assign an IP address on the Network
Settings page. For complete information about all of the fields and the
operation of this page, see Network Settings (on page 171).
1.
From the
Dominion KX II Local Console, choose Device Settings >
Network. The Network Settings page opens.
2. Specify a meaningful Device Name for your Dominion KX II device
using up to 16 alphanumeric characters, valid special characters,
and no spaces.
3. In the IPv4 section, enter or select the appropriate IPv4-specific
network settings:
a. Enter the IP Address if needed. The default IP address is
192.168.0.192.
b. Enter the Subnet Mask. The default subnet mask is
255.255.255.0.
c. Enter the Default Gateway if None is selected from the IP Auto
Configuration drop-down.