User guide

232
In This Chapter
Overview................................................................................................232
Accessing the Dominion KX
II Using CLI ..............................................233
SSH Connection to the Dominion KX II.................................................233
Telnet Connec
tion to the Dominion KX II ..............................................234
Loggi
ng On............................................................................................235
Navigation of the CLI.............................................................................236
Initial Configuration Using CLI
...............................................................238
CLI Prompts...........................................................................................239
CLI Commands......................................................................................239
Administering the Dominion KX II Console Serve
r
Configuration
Commands ............................................................................................240
Configuring Network
..............................................................................241
Overview
The Command Line Interface(CLI) can be used to configure the
Dominion KX II network interface and perform diagnostic functions
provided you have the appropriate permissions to do so.
The following figures describe an overview of the CLI commands. See
CLI Commands (on page 239) for a list of all the commands, which
inclu
de definit
ions and links to the sections in this chapter that give
examples of these commands.
The following common commands can be used from all levels of the CLI
to the preceding figure: top, history, log off, quit, show, and help.
Note: Both IPv4 and IPv6 addresses are supported.
Chapter 11
Command Line Interface (CLI)