User guide

CHAPTER 3: RARITAN REMOTE CLIENT (RRC) 23
Note: If using dynamic DHCP addressing, select the option button to Find Dominion KX by Name (please
note that the Find by Name function works only within the DKX subnet). The factory default unit name for
each Dominion KX produced is Dominion KX. To change the default name on a Dominion KX unit and
institute a unique name, please see Chapter 4.
For a Dial-Up Connection, enter the dialing parameters that RRC should use to establish a connection:
− Phone Number: Be sure to include any additional codes that RRC should dial to establish a
connection, such as country codes, area codes, or outside line access codes.
− Modem: Select the modem, as configured in Windows, which RRC should use to dial and connect
to your Raritan device.
Select a TCP Port to use:
− Use Default Port Number: Dominion KX is configured by default to use TCP Port 5000 for
communicating with RRC. Dominion KX can be configured to use a different TCP Port (see
Chapter 4: Administrative Functions, Network Configuration); if so, uncheck the Use Default
Port Number option, and enter the configured TCP Port to be used.
b. Compression tab
Figure 22 Compression Tab
Settings under the Compression tab are adjustable via the RRC client, and not necessary for pre-
configuration in the Connection Profile. If you wish to pre-configure these settings, however, please
refer to the section Connection and Video Properties in this chapter.
c. Security tab
Figure 23 Security tab
If you have configured your Dominion KX unit to use a private security key (see Chapter 4:
Administrative Functions, System-Level Security Parameters), enter it here in order to be authorized