Specifications

70 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE

Delete a PowerStrip Connected to a KX, KX2, or P2SC Device

You cannot delete a PowerStrip connected to a KX or KX2 device from CC-SG. You must

physically disconnect the PowerStrip from the KX or KX2 device to delete the PowerStrip from

CC-SG. When you physically disconnect the PowerStrip from a KX or KX2 device, the

PowerStrip and all configured outlets disappear from the Devices tab.

Configuring PowerStrips Connected to SX 3.0 and KSX

You can perform the following tasks in CC-SG to configure and manage PowerStrips connected

to SX 3.0 or KSX devices.

Note: PowerStrips must be physically connected to the Power Port of a KSX device.

• Add a PowerStrip Connected to an SX 3.0 or KSX Device

• Delete a PowerStrip Connected to an SX 3.0 or KSX Device

• Change a PowerStrip’s Device or Port Association (SX 3.0, KSX)

Add a PowerStrip Connected to an SX 3.0 or KSX device

Add the SX 3.0 or KSX device to CC-SG.

2. On the Devices menu, click Device Manager, Add Device.

3. Select PowerStrip from the Device type drop-down menu.

Figure 64 Adding a PowerStrip device

3. Type a name for the PowerStrip in the Power Strip Name field. Hold your cursor over the

field to see the number of characters allowed in the name. Spaces are not permitted.

4. Click the Number of Outlets drop-down menu and select the number of outlets this

PowerStrip contains.

5. Click the Managing Device drop-down menu, and then select the SX 3.0 or KSX device that

is connected to this power strip.