Specifications

40 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
Figure 31 Adding a Discovered Device
8. Type the user name and password (that were created specifically for CC-SG in the device) in
the Username and Password fields to allow CC-SG to authenticate the device when
communicating with it in the future. Select the Categories and Elements you want to apply
to the device. If you want a Category and Element to apply to the nodes connected to the
device, check the corresponding Apply to Nodes checkbox.
9. (Optional) Edit the Device Name, Heartbeat Timeout, Local Access (if available for the
device type), Description, Configure all ports, and Device Association fields.
10. When you are done configuring this device, click Apply to add this device and open the Add
Device screen for the next discovered device. Or, click OK to add this device without
continuing to the other discovered devices.
11. If the firmware version of a device is not compatible with CC-SG, a message will alert you
and ask if you want to proceed. Click Yes to add the device to CC-SG, or No to cancel the
operation. You can upgrade the device firmware after adding the device to CC-SG. Please
refer to Upgrade Devices later in this chapter for additional information.
Edit Device
You can edit a device to rename it and modify its properties.
1. Click the Devices tab and select the device you want to edit.