Specifications

CHAPTER 5: ADDING DEVICES AND DEVICE GROUPS 39
Discover Devices
Discover Devices initiates a search for all devices on your network. The search can automatically
detect all new and previously existing Raritan devices on your network, including Paragon II
System Controller, IP-Reach, Dominion KX, Dominion KX101, Dominion KSX, Dominion SX,
and eRIC units. After discovering the devices, you may add them to CC-SG if they are not
already managed.
1. On the Devices menu, click Discover Devices.
Figure 29 Discover Devices Screen
2. Type the range of IP addresses where you expect to find the devices in the From Address
and To Address fields. The To Address should be larger than the From Address. Specify a
mask to apply to the range. If a mask is not specified, then a broadcast address of
255.255.255.255 is sent, which broadcasts to all local networks. To discover devices across
subnets, you must specify a mask.
3. Check Broadcast discovery if searching for devices on the same subnet on which CC-SG
resides. Uncheck Broadcast discovery to discover devices across different subnets.
4. To search for a particular type of device, select it in the list of Device types. By default, all
device types are selected. Use CTRL+click to select more than one device type.
5. Check Include IPMI Agents if you want to find targets that provide IPMI power control.
6. Click Discover to start the search. At any time during the discovery, you can click Stop to
discontinue the discovery process. Discovered devices appear in a list.
Figure 30 Discovered Devices List Window
7. To add one or more discovered devices to CC-SG, select the devices from the list, and then
click Add. The Add Device screen appears with some of the data already populated. If you
selected more than one device to add, you can click Previous and Skip at the bottom of the
screen to navigate through the Add Device screens for the devices you want to add.