Specifications

CHAPTER 13: ADVANCED ADMINISTRATION 213
Editing Diagnostic Console Configuration
The Diagnostic Console can be accessed via the serial port (COM1), VGA/Keyboard/Mouse
(KVM) port, or from Secure Shell (SSH) clients. For each port type, you can configure whether
or not status or admin logins are allowed, and whether field support can also access Diagnostic
Console from the port. For SSH clients, you can also configure which port number should be used,
as long as no other CC-SG service is using the desired port.
To edit Diagnostic Console configuration:
1. On the Operation menu, click Diagnostic Console Config.
2. Determine how you want the Diagnostic Console configured and accessible. There are three
Diagnostic Console Access mechanisms: Serial Port (COM1), KVM Console, SSH (IP
network). The Diagnostic Console offers three services: Status Display, Admin Console,
Raritan Field Support. This screen allows the selection of which services are available via the
various access mechanisms.
3. Type the port number you want to set for SSH access to Diagnostic Console in the Port field.
The default port is 23.
Important: Be careful not to completely lockout all Admin or Field Support
access.
Figure 192 Edit Diagnostic Console Configuration
4. Click Save.
Editing Network Interfaces Configuration (Network Interfaces)
In Network Interface Configuration, you can perform initial setup tasks, such as setting the
hostname and IP address of the CC-SG.
1. Click Operation, Network Interfaces, and then click Network Interface Config.