Specifications

168 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
What is Active/Active mode?
Active/Active mode allows you to use CC-SG to manage devices and nodes that are on two
separate networks. In this mode, CC-SG manages traffic between the two separate IP domains.
Active/Active mode does not offer failover. If either LAN connection fails, users won’t have
access.
Please refer to
About CC-SG LAN Ports for the locations of the Primary LAN and Secondary
LAN ports on each CC-SG model.
Note: Clustering cannot be configured when using Active/Active mode.
Figure 150 Active/Active Network
Setup for Active/Active mode
When implementing Active/Active mode for your CC-SG network:
• Each CC-SG LAN port must be connected to a different sub-network.
• Raritan devices must be connected to the Primary LAN only.
• Clients and nodes may be connected to either the Primary LAN or the Secondary LAN.
• Specify at most one Default Gateway in the Network Setup panel in CC-SG. Use Diagnostic
Console to
add more static routes if needed. Please refer to Editing Static Routes on page
216 for details.
To configure Active/Active mode in CC-SG
1. On the Administration menu, click Configuration.
2. Click the Network Setup tab.