User's Manual

Setting Up Outlets and Power Thresholds

5. ClickApply.Thenewnameisapplied.

Setting the Outlet Thresholds

Tosetthecurrentthresholdsofanoutlet:

1. ChoosePowerOutlets‐‐>OutletSetup.TheOutletSetupwindow

appears.

2. Selectanoutletfromthedrop‐downlistintheShowsetupofoutlet

field.

3. TypeanumberinthefieldlabeledPoweroffperiodduringoutlet

powercycling.Wh

enanoutletispowercycled,itisturnedoffand

thenbackon.Thenumberyouenterheredeterminesthelengthof

time(inseconds)ittakesfortheoutlettoturnbackonafteritisshut

downduringthepowercycle.Ifleftblank,thisoutletwillusethe

luesetintheUnitSetuppageasadefault.

Note:YoucanpowercycleanoutletfromtheOutletDetails

window.Referto“PowerCyclinganOutlet(onpage72)”sectionfor

instructions.

4. SettheRMScurrentthresholdsfortheoutletintheThresholds

panel.

5. Whenyouarefinished,clickApply.Thesetupdetailsareapplied.