User's Manual

Connect the Dominion PX to Your Network
12




2. Plugtheotherendofthenull‐modemcable(containingtheDB9
connector)intotheserialport(COM)ofthecomputer.
Connect the Dominion PX to Your Network
TousetheWebinterfacetoadministertheDominionPX,youmust
connecttheDominionPXtoyourlocalareanetwork(LAN).
1. TakeastandardCategory5eUTPcableandconnectoneendtothe
LANportonthefrontoftheDominionPX.(Refertothepictures
showninConnecttheDo
minionPXtoaComputer(onpage11)for
thelocationofthisportonyoursizeDominionPX.)
2. ConnecttheotherendofthecabletoyourLAN.
Configure the Dominion PX for Network Connectivity
OncetheDominionPXisconnectedtoyournetwork,youmustprovide
itwithanIPaddressandsomeadditionalnetworkinginformation.
1. GotothecomputerthatyouconnectedtotheDominionPXand
openacommunicationsprogramsuchasHyperTerminalorPuTTY.
Makesureitsportsettingsareconfiguredasfo
llows: