User's Manual

Chapter 3: Installation and Configuration
11
Fill Out the Equipment Setup Worksheet
AnEquipmentSetupWorksheetisprovidedinAppendixB(see
ʺEquipmentSetu
pWorksheetʺonpage121).Usethisworksheetto
recordthemodel,serialnumber,anduseofeachdeviceconnectedtothe
DominionPX.
Asyouaddandremovedevices,keeptheworksheetuptodate.
Connect the Dominion PX to a Computer
YoumustconnecttheDominionPXtoacomputertoconfigureit.Thisis
donebymeansofaserialconnectionbetweentheDominionPXandthe
computer.IfyouplantousethisconnectiontologintotheCLP
commandlineinterface,leavethecableconnectedaftertheconfiguration
iscomplete.
Thecomputermustha
veacommunicationsprogramsuchas
HyperTerminalorPuTTY.Youwillalsoneedthenull‐modemcableand
connectorsthatwereshippedwiththeDominionPX.
1. Takethenull‐modemcableandconnecttheendwiththeRJ‐45
connectortotheportlabeledSerialonthefrontoftheDominionPX.
(Re
fertothefollowingpicturesforthelocationofthisportonyour
DominionPX.)
