User's Manual

Chapter 5: Using the Web Interface

Note:NoprogramsarecurrentlyavailabletousetheSetupProtocol

withDominionPX.Itissafetoleavethisdisabled.

6. Whenyouarefinished,clickApply.Thesettingsaremodified.

Modifying the LAN Interface Settings

TheLANinterfacespeedandduplexmodeweresetduringthe

installationandconfigurationprocess(refertofordetails).Tomodify

eithersetting:

1. ChooseDeviceSettings‐‐>Network.TheNetworkSettingswindow

appears.TheLANInterfaceSettingspanelonthebottomright

showstheinterfacespeedandduplexmode.



2. Tochangetheinterfacespeed,selectthespeedyouwantfromthe

drop‐downlistintheLANInterfaceSpeedfield.Yourchoicesare:

 Autodetect(systemselectsoptimumspeed)

 10Mbps

 100Mbps

3. Tochangetheduplexmode,selectthemodeyouwantfromthe

drop‐downli

stintheLANInterfaceDuplexModefield.Your

choicesare:

 Autodetect(systemselectsoptimummode)

 Halfduplex

 Fullduplex

4. HalfduplexallowsdatatobetransmittedtoandfromtheDominion

PX,butnotatthesametime.Fullduplexallowsdatatobe

tra

nsmittedinbothdirectionsatthesametime.

5. Whenyouarefinished,clickApply.Thesettingsaremodified.