User's Manual

Chapter 5: EMX Device Management
78
 Auto: An icon is displayed for this port only when the EMX device
detects the physical connection of the LHX heat exchanger on
this port. Otherwise, nothing is displayed. This is the default
approach.
 Pinned: An icon is displayed for this port all the time, but the icon
image varies according to the connection status. See Device
States and Icon Variations (on page 196).
When the Pinned checkbox is selected, click the drop-down
arrow to select the appropriate device type for this port: LHX 20
or LHX 40.
4. Click OK to save the changes.
In the tree, the icon, if present, is followed by the device name if
available, device type and the port number or FEATURE port (if
applicable).
Modifying the Network Configuration
The network settings you can change via the web interface include
wired, wireless, IPv4 and/or IPv6 settings.
Modifying the Network Interface Settings
The EMX supports two types of network interfaces: wired and wireless.
You should configure the network interface settings according to the
networking mode that applies. See Connecting the EMX to Your
Network (on page 14).
Wired Network Settings
The LAN interface speed and duplex mode were set during the
installation and configuration process. See Initial Network
Configuration (on page 15).
By default, the LAN speed and duplex mode are set to "Auto"
(automatic), which works in nearly all scenarios. You can change them if
there are special local requirements.
To modify the network interface settings:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
2. The Interface Settings tab should have been selected. If not, click the
Interface Settings tab.
3. In the Network Interface field, click the drop-down arrow, and select
Wired from the list.