User's Manual

Chapter 3: Getting Started
47
Section
Information shown
The measurement unit for the selected environmental
sensor appears.
The measurement unit varies according to the sensor
type:
 % is displayed for a humidity sensor.
 is displayed for a temperature sensor.
When the term "ASSET" appears, the displayed
information is associated with asset sensors and asset
tags.
Control Buttons
There are four control buttons.
 Up and Down buttons for selecting a specific ID or port number
 MODE button for switching between different types of target
information, including environmental sensor information, asset
management information, and MAC address
 FUNC button for switching between different types of data for a
selected environmental sensor
By default the display panel shows the first environmental sensor listed
on the External Sensors page of the web interface until you select a
different environmental sensor or a different target.
Environmental Sensor Information
The environmental sensor information is displayed as "SENSOR" in the
LCD display. Operate the LCD display to view information about the
selected environmental sensor, including the sensor reading or state, the
sensor's physical port number, X, Y, Z coordinates and its serial number.
To display the environmental sensor information:
1. Press the Up or Down button until the desired environmental
sensor's ID number is displayed in the top of the LCD display. See
LCD Display (on page 45). For example, "SENSOR 1" refers to the
#1 sensor listed on the External Sensors page of the web interface.
 Pressing the (UP) button moves up one selection.
 Pressing the (DOWN) button moves down one selection.
 "1 SENSOR 24" refers to the #124 sensor.
Note: Press and hold the Up or Down buttons for at least two (2)
seconds to quickly move through several items at once.