User's Manual

Chapter 2: Installing and Configuring the EMX Device

Note: Each tag port on the blade extension strip is labeled a number,

which is displayed as the slot number in the EMX's web interface.

To install a blade extension strip:

1. Connect the tag connector cable to the blade extension strip.

 Plug the cable's connector into the socket at either end of the

blade extension strip.

2. Move the blade extension strip toward the bottom of the blade

chassis until its mylar section is fully under the chassis, and verify

that the blade extension strip does not fall off easily. If necessary,

you may use the adhesive tape in the back of the mylar section to

help fix the strip in place.

3. Connect one end of an asset tag to a blade server and connect the

other end to the blade extension strip.

a. Affix the adhesive part of the asset tag to one side of a blade

server through the tag's tape.