User's Manual

Index
367
Record Snapshots to Webcam Storage • 143
Reset Button • 50
Resetting the EMX • 322
Resetting the PM710 Minimum and Maximum
Values • 199
Resetting to Factory Defaults • 50, 102, 322
Resetting to Factory Defaults (CLI) • 328
Restarting the Device • 322
Restricted Service Agreement • 216
Retrieving Previous Commands • 327
Role Configuration Commands • 307
Role of a DNS Server • 84, 356
Role-Bassed Access Control • 274
RS-485 Port Pinouts • 352
S
Sample Asset-Management-Level Event Rule
• 154
Sample Event Rules • 154
Sample Sensor-Level Event Rule • 155
Sample User-Activity-Level Event Rule • 156
Saving an EMX Configuration • 95
Schroff LHX Heat Exchangers • 42, 58, 143,
192
Security • 104
Security Configuration Commands • 258
Security Settings • 225
Selecting IPv4 or IPv6 Addresses • 236
Selecting the Internet Protocol • 81, 82, 83
Send a Snapshot via Email • 137
Send an SNMP Notification • 139
Send EMail • 138
Send SMS Message • 142
Sending Videos in an Email or Instant
Message • 184, 190
Sensor Measurement Accuracy • 178
Sensor RJ-12 Port Pinouts • 352
Serial • 225
Serial Port Configuration Commands • 312
Serial RS-232 Port Pinouts • 352
Server Accessibility • 164
Setting an LED Color for a Rack Unit • 317,
318
Setting an LED Mode for a Rack Unit • 317,
319
Setting Data Logging • 176, 234
Setting EMX Asset Sensor LED Colors • 345
Setting the Authentication Method • 238
Setting the BSSID • 242
Setting the Data Logging Measurements Per
Entry • 234
Setting the Date and Time • 73
Setting the EAP Identity • 240
Setting the EAP Parameters • 239
Setting the EAP Password • 240
Setting the History Buffer Length • 320
Setting the Inner Authentication • 239
Setting the IPv4 Address • 244
Setting the IPv4 Configuration Mode • 243
Setting the IPv4 Gateway • 245
Setting the IPv4 Preferred Host Name • 243
Setting the IPv4 Primary DNS Server • 245
Setting the IPv4 Secondary DNS Server • 246
Setting the IPv4 Subnet Mask • 244
Setting the IPv6 Address • 248
Setting the IPv6 Configuration Mode • 247
Setting the IPv6 Gateway • 248
Setting the IPv6 Primary DNS Server • 249
Setting the IPv6 Secondary DNS Server • 249
Setting the LAN Interface Parameters • 250
Setting the LED Disconnect Color • 318
Setting the LED Operation Mode • 317
Setting the Network Service Parameters • 251
Setting the Networking Mode • 235
Setting the NTP Parameters • 305
Setting the Outer Authentication • 239
Setting the PSK • 238
Setting the Sensor's Assertion Timeout • 289
Setting the Sensor's Deassertion Hysteresis •
288
Setting the Sensor's Lower Critical Threshold •
286
Setting the Sensor's Lower Warning Threshold
• 287
Setting the Sensor's Upper Critical Threshold •
284
Setting the Sensor's Upper Warning Threshold
• 285
Setting the Serial Port Baud Rate • 312
Setting the SNMP Configuration • 255
Setting the SNMP Read Community • 256
Setting the SNMP Write Community • 257
Setting the SSID • 237
Setting the sysContact Value • 257
Setting the sysLocation Value • 258
Setting the sysName Value • 258
Setting the Wireless Parameters • 237
Setting the X Coordinate • 282
Setting the Y Coordinate • 282
Setting the Z Coordinate • 233, 283
Setting the Z Coordinate Format • 174
Setting the Z Coordinate Format for
Environmental Sensors • 233, 283