User's Manual

Appendix B: Integrating EMX and Asset Management Sensors with dcTrack
348
 To assign an IP address, select a subnet. This automatically
assigns the first available address from the selected subnet. You
can change the address by manually typing another address in
the subnet, or using the drop-down to view all the available
addresses in that subnet.
a. If needed, enter comments pertinent to the port.
b. Enter the SNMP community name the port is associated with.
Note: After adding a Humidity/Temperature sensor to an EMX, make
sure that the Order column in dcTrack is the same order on the EMX.
c. Click Create Port.
11. Click Detail 2 to open the Detail 2 page for the EMX, then enter any
additional information that is needed. Optional
12. Click Save. The saved item is tagged with a status of New. The item
appears in red on the cabinet elevation, which indicates that the item
is new.