User's Manual

Appendix A: Using Raritan Asset Management Sensors with the EMX
338
2. Move the blade extension strip toward the bottom of the blade
chassis until its mylar section is fully under the chassis, and verify
that the blade extension strip does not fall off easily. If necessary,
you may use the adhesive tape in the back of the mylar section to
help fix the strip in place.
3. Connect one end of an asset tag to a blade server and connect the
other end to the blade extension strip.
a. Affix the adhesive part of the asset tag to one side of a blade
server through the tag's tape.
b. Plug the tag connector of the asset tag into the tag port on the
blade extension strip.
4. Repeat the above step until all blade servers in the chassis are
connected to the blade extension strip via asset tags.