User's Manual

Chapter 2: Installing and Configuring the EMX Device
23
 Make sure that the U-shaped sheet metal adjacent to the male
DIN connector is inserted into the rear slot of the master asset
sensor. Screw up the U-shaped sheet metal to reinforce the
connection.
2. Connect another 8U slave asset sensor to the one being attached to
the master asset sensor in the same manner as Step 1.
3. Repeat the above step to connect more slave asset sensors. The
length of the asset sensor assembly can be up to 64U.
 The final asset sensor can be 8U or 5U, depending on the actual
height of your rack.
 Using the "ending" asset sensor as the final asset sensor is
strongly recommended.
4. Vertically attach the asset sensor assembly to the rack, next to the IT
equipment, making each tag port horizontally align with a rack unit.
The asset sensors are automatically attracted to the rack because of
magnetic stripes on the back.
Note: The asset sensor is implemented with a tilt sensor so it can be
mounted upside down.